Hi,
I do use RO-DI water to mix triton 3a and 3b. It only happened once, but it's a big problem because as I walk past my doser I check fluid levels and all are fine, until today I was wondering why isn't the level dropping and I picked one bottle up only to notice the entire bottom (3cm up from the bottom) is rock hard and my feed line end is stuck in there! I had problem pulling the line out. Which means it was not dosing for who knows how long.
This happened to both 3a and 3b at the same time.
Anybody had same thing happen?
I do use RO-DI water to mix triton 3a and 3b. It only happened once, but it's a big problem because as I walk past my doser I check fluid levels and all are fine, until today I was wondering why isn't the level dropping and I picked one bottle up only to notice the entire bottom (3cm up from the bottom) is rock hard and my feed line end is stuck in there! I had problem pulling the line out. Which means it was not dosing for who knows how long.
This happened to both 3a and 3b at the same time.
Anybody had same thing happen?