- Joined
- Jun 8, 2018
- Messages
- 1,149
- Reaction score
- 642
GOOD MORNING ALL.
I have woke to 98 alarms on my apex that are coming from one of my DDR sensors. I find this odd because the container's sensor is covered by AB+. When I set up my cold dosing using this DDR. I wondered about how much fluid would be required before the sensor tripped; given the fact that it is a raised sensor.
This past Monday I added 500ml of AB+ in the side that's tripping (150ope/150amo) I set the starting dose amount at 10 ml daily to be dosed at 21:00-21:04. So over three days, I have only dosed 30 ml. Will adding more fluid stop this switch from going off? I mean 500ml is still a lot and the sensor is covered. seem like one could get more time before the alarm trips. or is it tipping in error?
secondly, I have noticed that I have to keep revising the DDR container levels. the starting levels for both sides were -----150TE at 800ml, and 150AMO(150OPE sensor) was set at 500ml. ----------so why over the past three days have these levels rose according to my dashboard? when the DDR runs in reverse it adds air in the form of bubbles to the container when clearing the line is ongoing, could these bubbles be the issue? but this bubbling happens only at 21:00, not 00:00 when the alarms are going off.
again I have had 98 alarms go off since midnight until now (8 am) on the 150amo side and the optic sensor is covered with AB+. THANKS IN ADVANCE.
I have woke to 98 alarms on my apex that are coming from one of my DDR sensors. I find this odd because the container's sensor is covered by AB+. When I set up my cold dosing using this DDR. I wondered about how much fluid would be required before the sensor tripped; given the fact that it is a raised sensor.
This past Monday I added 500ml of AB+ in the side that's tripping (150ope/150amo) I set the starting dose amount at 10 ml daily to be dosed at 21:00-21:04. So over three days, I have only dosed 30 ml. Will adding more fluid stop this switch from going off? I mean 500ml is still a lot and the sensor is covered. seem like one could get more time before the alarm trips. or is it tipping in error?
secondly, I have noticed that I have to keep revising the DDR container levels. the starting levels for both sides were -----150TE at 800ml, and 150AMO(150OPE sensor) was set at 500ml. ----------so why over the past three days have these levels rose according to my dashboard? when the DDR runs in reverse it adds air in the form of bubbles to the container when clearing the line is ongoing, could these bubbles be the issue? but this bubbling happens only at 21:00, not 00:00 when the alarms are going off.
again I have had 98 alarms go off since midnight until now (8 am) on the 150amo side and the optic sensor is covered with AB+. THANKS IN ADVANCE.