I've setup an FMM with a lo and hi sensor in my 65 gallon fresh water barrel. My hope is that if the barrel gets to ~30 gallons (where the bottom sensor is) it will open the solenoid and run my RODI until the hi sensor is closed. Right now, the lo sensor is acting like ATO and turning on/off only based on the open/close of the lo sensor. My code is below; please help!
Fallback OFF
Set OFF
If AWClow OPEN Then ON
If AWCHi CLOSED Then OFF
When On > 360:00 Then OFF
Fallback OFF
Set OFF
If AWClow OPEN Then ON
If AWCHi CLOSED Then OFF
When On > 360:00 Then OFF