I'd like to setup my RODI reservoir to automatically refill as need. I have a RO_HI optical sensor and an RO_LOW optical sensor inside the reservoir. I have a buster pump, RODI_PUMP, plugged into my EB832. I also have an Apex solenoid placed between my house water supply and the RODI_PUMP. I need the solenoid to open and then the RODI_PUMP to turn on when the water level in the reservoir is low and shut off when it is full. I believe I need a virtual outlet to make this work, correct?
RODI_RES (virtual outlet)
If RO_Hi = Closed Then OFF
If RO_LOW = Open Then On
RODI_SOL
Fallback OFF
Set OFF
If Output RODI_RES = ON Then ON
RODI_PUMP
Fallback OFF
Set OFF
If Output RODI_RES = ON Then ON
Does that look about right?
RODI_RES (virtual outlet)
If RO_Hi = Closed Then OFF
If RO_LOW = Open Then On
RODI_SOL
Fallback OFF
Set OFF
If Output RODI_RES = ON Then ON
RODI_PUMP
Fallback OFF
Set OFF
If Output RODI_RES = ON Then ON
Does that look about right?