- Joined
- Jan 31, 2019
- Messages
- 369
- Reaction score
- 166
Hi guys,
I would like to configure my magnetic stirrer to a switch port, then use a timer to trigger the Switch port to stir at given times of the day (these will be a few minutes before a schedule for a head on a Doser v1). All the heads on my Doser 2 are used so I can't just use the built in functions for Profilux (3).
My stirrer is plugged into port 5 and works if I manually override it (as per below).
However when I associate it to a Switch port (config below) and manually switch the port on the stirrer does not stir.
I am assuming by switching on "switch channel 1" (as noted above) it should run the stirrer plugged into Doser head 5 (as per 1st picture).
Am I missing something?
As a second and separate question, if I enable to "automatic stir" as per below (4 cycles of 60 seconds) how do I know what time these will trigger at (so I can watch and ensure it is actually working)
Thanks in advance.
I would like to configure my magnetic stirrer to a switch port, then use a timer to trigger the Switch port to stir at given times of the day (these will be a few minutes before a schedule for a head on a Doser v1). All the heads on my Doser 2 are used so I can't just use the built in functions for Profilux (3).
My stirrer is plugged into port 5 and works if I manually override it (as per below).
However when I associate it to a Switch port (config below) and manually switch the port on the stirrer does not stir.
I am assuming by switching on "switch channel 1" (as noted above) it should run the stirrer plugged into Doser head 5 (as per 1st picture).
Am I missing something?
As a second and separate question, if I enable to "automatic stir" as per below (4 cycles of 60 seconds) how do I know what time these will trigger at (so I can watch and ensure it is actually working)
Thanks in advance.