Tofu Brady
Active Member
Hello, I recently got the auto aqua AWC I was wondering where you could put it for the Waterbox 20 cube thanks because this could help out with stability.
AWC in AIO
- Thread starter Tofu Brady
- Start date
- Tagged users None
OP
OP
Tofu Brady
Active Member
It’s about 18 inches long 18 inches deep and about 3.5 inches wide
paparoof
Active Member
I dont have a waterbox, but I have that AWC in the back of an AIO (Innovative Marine 30L). In my opinion ya pretty much have to put the sensors in the return pump section. The max waterchange I can get is 1.5 gallons unless I do a bunch of manual monkeying around during the water change which defeats the whole point of an AUTO water change.
Put the low water sensor just above the point where the return pump will start sucking air if the water level gets any lower.
Put the low water sensor just above the point where the return pump will start sucking air if the water level gets any lower.
Similar threads
