Folks,
A few searches yielded a few clues, but I'm stumped on how to make this work properly. Here is what I'm trying to do:
I have an Avast Kalk Stirrer I would like to use to dispense Kalk at night, to supplement my CA Reactor and possibly get a PH boost as well. I have a DOS connected to my stirrer, and to my reservoir that is about 5 feet away. The issue I have is that my pump moves too slowly to properly fill the stirrer, and start a drip. How can I speed up the pump to make this work?
I'd like to drip a small amount of kalk, say 20-50 ml to start, but simply can't get the DOS to pull the water fast enough. (If I set it up using the wizard for a water change, it works great, as the pump spins much faster, but I can't get good control on how much I dose using that method)
I'm grateful for any advice and help!
Thanks!
A few searches yielded a few clues, but I'm stumped on how to make this work properly. Here is what I'm trying to do:
I have an Avast Kalk Stirrer I would like to use to dispense Kalk at night, to supplement my CA Reactor and possibly get a PH boost as well. I have a DOS connected to my stirrer, and to my reservoir that is about 5 feet away. The issue I have is that my pump moves too slowly to properly fill the stirrer, and start a drip. How can I speed up the pump to make this work?
I'd like to drip a small amount of kalk, say 20-50 ml to start, but simply can't get the DOS to pull the water fast enough. (If I set it up using the wizard for a water change, it works great, as the pump spins much faster, but I can't get good control on how much I dose using that method)
I'm grateful for any advice and help!
Thanks!