So I have the cor 20 on stand alone mode. Finally decided to attempt to set the feed mode and see how it works. The cor 20 is running roughly at 50% or so according to the lights. It's a waterbox 130.4 tank currently cycling.
Here is the issue, when setting the feed mode. I have it on the lowest setting possible without pump turning off. And it slows down. Barely pumps out the nozzle like its suppose to but the waterline does not get under the overflow baffles so it seems water still pours into the overflow. how do I get it to drop below the baffle so food wont go back there? Especially since it's on the lowest setting. If I press the lower speed button it again it stops fully.
Here is the issue, when setting the feed mode. I have it on the lowest setting possible without pump turning off. And it slows down. Barely pumps out the nozzle like its suppose to but the waterline does not get under the overflow baffles so it seems water still pours into the overflow. how do I get it to drop below the baffle so food wont go back there? Especially since it's on the lowest setting. If I press the lower speed button it again it stops fully.