DIY Dosing Stand Kit

[cromag27]

Don’t want to spend a fortune on dosing containers? Water bottles have become very popular to use as dosing containers. The biggest issue is that they can tip over easily – but fear not, for I have a fancy solution for you!

• Will support bottles up to 3″ diameter.
• Includes three 1/4″ all plastic quick connect bulkheads.
• Includes three 1/4″ tubing for inside the bottles.
• Stand is made from quality 1/4″ cast acrylic, with mounting screw holes pre-drilled and a cut out handle (except single.)
• Bottles are not included.
• Available in black and white.
• Works with small and large VOSS bottles as well!

Approximate sizes:

Single: 4.125" wide x 4.25" deep x 6" tall
Double: 7.25" wide x 4.25" deep x 6" tall
Triple: 10.5" wide x 4.25" deep x 6" tall
Quad: 13.75" wide x 4.25" deep x 6"tall


Order HERE.



Step 1:

Use a 5/8″ drill bit (I’ve found the forstner bit works best) and drill holes in the center of each cap.

Step 2:

Push the bulkhead through the hole and tighten the screw on the bottom side. This could be a snug fit but you’ll get it!

Step 3:

Connect the supplied tubing and enjoy!

 

[KJAG]

Very nice I’ll be grabbing a couple of these at some point.

 

[Fin]

I liked mine, until I saw this. Darn you @cromag27 !

 

[gtrider]

I'm about to set-up my doser, was googling around for a container and found this. Excellent! i placed an order yesterday.