So I decided that since these cups seal pretty well, and they're readily available, I'd make a stand to hold up frag plugs "neatly" if I decided to use these for trading/selling frags. It's a lot easier (for me) than using baggies and it holds up the frag and keeps it from bouncing around the sides of the container.
My first design had 4 holes for frags and the "legs" were in an "X" pattern. I found out rather quickly that the design sucked if you only put in 1 frag, as the other side of the stand would float up, or be pushed up by the weight of the single frag. So on to version 2.0 in which I added another hole for a frag plug in the middle of the stand (specifically for single frags) and move the legs so they're curved with the side of the stand. This serves two purposes, 1, it move the legs so I could add the single hole for the frag in the center, and 2, with the legs on the very edges, it's less likely to "fall over" as any weight will be on the leg.
Anyway, It's not like it's some masterpiece, but it works for me.
My first design had 4 holes for frags and the "legs" were in an "X" pattern. I found out rather quickly that the design sucked if you only put in 1 frag, as the other side of the stand would float up, or be pushed up by the weight of the single frag. So on to version 2.0 in which I added another hole for a frag plug in the middle of the stand (specifically for single frags) and move the legs so they're curved with the side of the stand. This serves two purposes, 1, it move the legs so I could add the single hole for the frag in the center, and 2, with the legs on the very edges, it's less likely to "fall over" as any weight will be on the leg.
Anyway, It's not like it's some masterpiece, but it works for me.