- Joined
- Jun 5, 2020
- Messages
- 66
- Reaction score
- 102
Hello everyone. I'm getting ready to build a ULM mixed 80gallon tank. I work in automation so I of course need to put my experience to use on this tank. I'm planning on going just enough automation I don't neglect the tank.
I do however want to save as much room and make it clean as can be when I build it. I was wondering if anyone has thrown out all the power bricks and used a DC power supply with a distribution board? I'm thinking that route to save tons of room. I know the downside is if it goes every thing goes but I'm planning a quality p/s with warning indicators incase of failure along with a back up.
Anyone else try this with success or failure? Thanks!
I do however want to save as much room and make it clean as can be when I build it. I was wondering if anyone has thrown out all the power bricks and used a DC power supply with a distribution board? I'm thinking that route to save tons of room. I know the downside is if it goes every thing goes but I'm planning a quality p/s with warning indicators incase of failure along with a back up.
Anyone else try this with success or failure? Thanks!