How do I reset the alarm on my Tunze Osmolator?

[djryan2000]

I had to drain my tank last weekend to get a fish out. I drained it into an old DT I had in my basement. The tank was too narrow for a 5g bucket so I used my ato to pump the water back into my tank, which went great until the alarm tripped alerting me the ATO pumped a lot of water. With my previous ATO, the solution was simply unplugging it for a minute or so, and then it would reset when I plug it back in. With the Tunze this did not work. Does anyone know how to reset this? Do I just turn off the high water level alarm and then turn it back on?

 

[Thaxxx]

It automatically shuts off after 10 mins. on continuously.
Unplugging should reset it. I know mine does.
Make sure the high level float isn't stuck in the off position.

 

[djryan2000]

It automatically shuts off after 10 mins. on continuously.
Unplugging should reset it. I know mine does.
Make sure the high level float isn't stuck in the off position.

Here’s what it does. heres a photo of it - I’m pretty sure it’s in the off position.

 

[Thaxxx]

I've never had mine flash all lights and alarm at once.
Do you have the manual?
If not I'm sure you can get it online.

 

[Blue Spot Octopus]

Something else happened, try contacting Roger at Tunze USA.

 

[JoshH]

Something else happened, try contacting Roger at Tunze USA.

We can always summon him @rvitko

 

[Blue Spot Octopus]

^^^^^ Yes that is the ticket. He is the man.