No to microscope but this might be the time to buy one!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Best way to cut acrylic is with a table saw fitted with a fence.Hey can I take a side off of this somehow? I wanna turn it into a Cora
what’s the best way to cut off the weirs
Best way to cut acrylic is with a table saw fitted with a fence.
You do not need a special blade. Really any rip or crosscut blade will work. The higher tooth count on the blade, the faster you will need to feed the work through the blade to keep it from melting. New prepared as this will throw around a lot of little pieces of acrylic. Drop the blade in the table so there is any 1/2" protruding. Make both long cuts, then short cuts. Ppe required.
Example below.
Yes. Sorry didn't mention, The picture I laid out was for the follow up, how do you cut off the weirs.For a viewer the black bit with the big hole needs removing and then just seal the two holes on the left, I used to make viewers but slightly differently.
Yes. Sorry didn't mention, The picture I laid out was for the follow up, how do you cut off the weirs.
dip for bacterial,put recession opposite flow for now...bummer hope for the best ,keeps going ,cut it ."Dear uncle Frank!" ;Nurse
dip for bacterial,put recession opposite flow for now...bummer hope for the best ,keeps going ,cut it .
Morning all!good morning all...
wet,cloudy,humid,one of them days here...
Yes that’s what we are talking aboutSorry lost again, the comb / teeth?
Lucky for me this box is the wet side of a HOB overflow kit. No holes except the ones I want to makeFor a viewer the black bit with the big hole needs removing and then just seal the two holes on the left, I used to make viewers but slightly differently.
T-storms, windy as heck and lots of rain here. Hopefully the break from it they have e predicted stays. Have a guy coming to look at my pathy, as I am gonna sell it.Apparently we all have the same weather currently.
Grey cloudy and rainy!
I don’t have a table saw. I have a miter saw. Can I use that? Or what if I mail it to you? LoL.Best way to cut acrylic is with a table saw fitted with a fence.
You do not need a special blade. Really any rip or crosscut blade will work. The higher tooth count on the blade, the faster you will need to feed the work through the blade to keep it from melting. New prepared as this will throw around a lot of little pieces of acrylic. Drop the blade in the table so there is any 1/2" protruding. Make both long cuts, then short cuts. Ppe required.
Example below.
Easier yet, 8 or 10" pvc slice, one piece of acrylic.Would be easier to buy one haha. Or make one from scratch. 5 pieces of acrylic and the right glue is all you need
I could easily modify it however you need if you want to send it here.I don’t have a table saw. I have a miter saw. Can I use that? Or what if I mail it to you? LoL.