My Reef-pi setup


New Member
Review score
+0 /0 /-0
View Badges
Jan 11, 2021
Reaction score
Review score
+0 /0 /-0
After a lot of questions and reading I finally have my Reef-Pi setup. Did some 3D printing to try and get a little fancy. Figured I would show it and see what else I can do with it. Still need to add a PH setup to it but I am quite happy with it! Does as much as any of the other controllers on the market (although I am waiting to see when Conductivity and ORP will come out!). And yeah I need to do some cable management still! lol

complete units.jpg
Main unit.jpg
Power bar.jpg

Have you ever torn down a tank over an issue you couldn't seem to beat?

  • Yes! I have. (Tell us about what issue you faced in the thread.)

    Votes: 176 24.2%
  • No. Thankfully, I haven't.

    Votes: 376 51.7%
  • Nope, but it almost happened. (Share your experience in the thread.)

    Votes: 53 7.3%
  • Not yet, but I'm almost there. (Tell us what you're dealing with.)

    Votes: 61 8.4%
  • If you reef long enough, this will eventually happen to you.

    Votes: 47 6.5%
  • Other

    Votes: 14 1.9%
A Reef Creation