- Joined
- Nov 16, 2016
- Messages
- 432
- Reaction score
- 164
Today my water in the sump ran really low. I have an ATO system set up with the PUMPv2. I noticed the PMUP was not running. I can unplug it and plug it back in and it immediately pumps water but then it steps and wont run again. This has nothing to do with my APEX programming because I'm testing by running it in a regular outlet.
Basically, plug it in and it turns on for 3 seconds, then its off.
Any ideas?
Basically, plug it in and it turns on for 3 seconds, then its off.
Any ideas?