- Joined
- Nov 2, 2018
- Messages
- 24
- Reaction score
- 5
Looking for some insight on my RODI system. Due to being on well water with high co2 I have to first run my water through the sediment and carbon block canisters and ro membrane then into a brute trash can for storage. That part goes fairly well and in what I consider a reasonable amount of time. I let that water gas off with a pump and large air stone for at least 48 hours. Next phase is pumping that water through my dual DI canisters with a pond pump sitting on the bottom of the brute can. This is where things drastically slow down. If I unhook the line going into the DI canisters I get a good strong stream of water shooting out. Once hooked back up and the water is passing through the canisters it slows to basically a quick drip. It can take up to 7 hours to make just 5 gallons of 0 tds water. Is that normal?