See i started it the other way but it endedbup this way lol. Its for the inside of the overflow correct?
All in inchs
A-3~
B-3~
C1- 5 5/8
C2 - 5 3/16
C3 - 4 1/2
All in inchs
A-3~
B-3~
C1- 5 5/8
C2 - 5 3/16
C3 - 4 1/2
Tenecor's $29* ReefPoint® 3 Gallon DIY Frag Kit Drops This Thursday
- Thread starter Tenecor Aquariums
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)
- Thread Starter
- #562
OP
The inside oveflow should be perfectly square unless the pieces were swapped. If the OF pieces were swapped, then this caddy will not fit
Gottcha nothings glued up yet, wanted to makesure i was half right. Still waiting for my weldon. Its a really neat design im happy to get this setup on my desk
- Thread Starter
- #564
OP
Stack the two OF pieces. The wider one goes on the front.
My sump just arrived! I was so excited to see the surprise envelope, but I wasn't sure what it was. I came running in here to see, and am glad someone else figured it out, and to have a picture for how to put it together 
- Thread Starter
- #567
OP
try dry fitting the caddy.
- Thread Starter
- #568
OP
dry fit it before gluing it up. after you assemble it and are satisfied with the final result, just add a little bit of solvent where the tabs and slots meet. No need to try and glue up every seam.My sump just arrived! I was so excited to see the surprise envelope, but I wasn't sure what it was. I came running in here to see, and am glad someone else figured it out, and to have a picture for how to put it together
Could someone post a pic of the media basket correctly assembled?
I'm not understanding - Mine looks just like Trixter's only the C2 is on the other side.
And which compartment does it go in?
I'm not understanding - Mine looks just like Trixter's only the C2 is on the other side.
And which compartment does it go in?
That is how I have mine. What compartment do you put it in?Hope this helps, i switched it around.
I am using Lifeguard Aquatics bulkheads in my frag tank build but they do not fit. I see that this is a common issue with this tank, so should I drill the holes out or possibly file them? It is off by 1/8". I do not want to chip the tank or effect the integrity by drilling so I would rather file or sand if I could. Any recommendations?
- Thread Starter
- #573
OP
Winner winner! Chicken dinner!Hope this helps, i switched it around.
- Thread Starter
- #574
OP
The overflow box. Place Floss on the top shelf. Your choice of Chem on the second. Or nothing. Or do not use it at all.
For those that have not bought bulkhead fittings yet these fit perfectly. Not sure how they stand up against Lifeguard but cheaper and fit the holes in the DIY tank.
Thank you!!For those that have not bought bulkhead fittings yet these fit perfectly. Not sure how they stand up against Lifeguard but cheaper and fit the holes in the DIY tank.
- Thread Starter
- #577
There were a few requests to see it assembled and with the tank on, which inspired me to get it done! The only thing I'm not sure about is how I'm going to secure the baffles. They fit pretty loose and there is no way each chamber will be water tight
