- Joined
- Jan 7, 2020
- Messages
- 311
- Reaction score
- 115
I just got my new Trident. I performed the recommended Trident initial setup procedure. And then after it performs the initialization process I got the message “No water sample”.
I then went to Trident website for troubleshooting. I followed the recommended course of actions until I tried everything to the end but no luck.
So I decided to try fixing it myself by opening the Trident. I noticed that the sample water line was kinked being attached to the white circular connector. See attached picture.
To avoid getting kinked again I decided to let it loose and not attached to the connector.
Luckily after reassembling back and reset Trident, to my excitement that error was gone and everything now works as it should.
I then went to Trident website for troubleshooting. I followed the recommended course of actions until I tried everything to the end but no luck.
So I decided to try fixing it myself by opening the Trident. I noticed that the sample water line was kinked being attached to the white circular connector. See attached picture.
To avoid getting kinked again I decided to let it loose and not attached to the connector.
Luckily after reassembling back and reset Trident, to my excitement that error was gone and everything now works as it should.