Hello.
I am new into the hobby and am using Well Water with my RO/DI. As others have experienced, I get about 30-40 gallons of life from the DI. I then implemented the solution as follows:
1.) Output of RO membrane into a 30gl Brute, with powerhead circulating water as the Brute fills up completely.
2.) I then feed the CO2 depleted water from Brute Garbage Can via powerhead to my DI RESIN using a SICCE 1.5 pump.
3.) Output of DI then goes into 5GL holding containers for future use. TDS = 0.
This has resulted in considerable higher usage rate of my DI cartridge. But..., it seems to take a very long time to push the water through the DI. I am wondering what GPH others are using with this solution to pump water through the DI. I am wondering what is the optimal flow, if there is one. Or what is too much that might reduce DI life?
Any help would be appreciated..thanks
I am new into the hobby and am using Well Water with my RO/DI. As others have experienced, I get about 30-40 gallons of life from the DI. I then implemented the solution as follows:
1.) Output of RO membrane into a 30gl Brute, with powerhead circulating water as the Brute fills up completely.
2.) I then feed the CO2 depleted water from Brute Garbage Can via powerhead to my DI RESIN using a SICCE 1.5 pump.
3.) Output of DI then goes into 5GL holding containers for future use. TDS = 0.
This has resulted in considerable higher usage rate of my DI cartridge. But..., it seems to take a very long time to push the water through the DI. I am wondering what GPH others are using with this solution to pump water through the DI. I am wondering what is the optimal flow, if there is one. Or what is too much that might reduce DI life?
Any help would be appreciated..thanks