Ok, I've decided I'm going to be ordering a Robo-Tank 2.0 controller when @robsworld78 releases them. As I get serious about this, I was wondering what you monitor/control with your reef-pi setup.
I'm thinking the following:
Direct equipment power control (I already have 2 Kasa HS300 strips) - Things I don't want to risk a Wifi failure causing issue:
* Main return pump
* Heater controller/Heater
* ATO
* Sump Fan (cool if temp too high)
Sensors:
* Sump pH
* Sump Temp
* Tank Temp
* ATO level x3 (Emergency low, Low, High)
* Sump level x 3 (Emergency low, Low, High)
* Overflow x 2 (Emergency Low, Emergency High)
Other control/sensors in the future:
* CO2 monitor
* Humidity monitor
* Jebao wavemakers
* Lights (maybe, current PopBloom lights not wired for control)
What else do you monitor/control? What do you consider to be the most important?
I'm thinking the following:
Direct equipment power control (I already have 2 Kasa HS300 strips) - Things I don't want to risk a Wifi failure causing issue:
* Main return pump
* Heater controller/Heater
* ATO
* Sump Fan (cool if temp too high)
Sensors:
* Sump pH
* Sump Temp
* Tank Temp
* ATO level x3 (Emergency low, Low, High)
* Sump level x 3 (Emergency low, Low, High)
* Overflow x 2 (Emergency Low, Emergency High)
Other control/sensors in the future:
* CO2 monitor
* Humidity monitor
* Jebao wavemakers
* Lights (maybe, current PopBloom lights not wired for control)
What else do you monitor/control? What do you consider to be the most important?
Last edited: