Sure. I honestly just want some brackets for things like Ecotech controllers and power bricks. Between all of those, it’ll be close to $300. Why not just buy a printer and do it myself? Seems like a no brainer
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Sure. I honestly just want some brackets for things like Ecotech controllers and power bricks. Between all of those, it’ll be close to $300. Why not just buy a printer and do it myself? Seems like a no brainer
Hey mate. Post a question about your nem in the clownfish and anemone forum if you’re not sure what’s going. They were super helpful over there when I needed advice!
That is super cool. Fingers are crossed !Ok, finally got the time to do this!!
I left the anemones light off this morning, so she’d be a bit more compact when moving.
With return pump and gyres switched off, idropped a 3” pvc union right where I wanted her to go and siphoned out a nice bare patch inside. Then I went downstairs and got the LTA in a small Tupperware container, lifted her out of that and into the DT (avoiding as much water xfer as possible, put her into the glass in the pvc union, gently lifted the union out and watched the sand gently settle around her. Success!!
Then she wiggled to the top of the sand, inverted and balled up. So I scooped out a bare patch as before, placed her down and practically covered her with sand.
Let her sit for 15 minutes then added return flow and gyres at 20% each
Before I’d even put the lid on, the clowns were investigating but have backed off for now. I fed everyone to make them happy again- Michael j Foxface went COMPLETELY BLACK- and I’ll start dialing up the flow every hour by 10% until I hit my regular levels
Dude. heck of a job! I can’t wait to get back in the lawn! [emoji26]