Triton Test Results received today

[Dreamkeeper]

Triton Test results received today,all parameters were good with the exception of:

Copper 3.88 ug/l set point .10 ug/l
Iodine 8.80 ug/l set point 60.00 ug/l
Phosphorus 2.40 ug/l set point 6.00 ug/l
Phosphate .007 mg/l set point 0.018 mg/l
surprised with Cu results as I never dosed it.
Any suggestions/ recommendations on the above?​

 

[ewelch]

I would be most concearned about the copper .

Did you buy the tank of equipment used ? Maybe previous owner dosed copper . If not I would look for the source . Faulty equipment , broken wire etc.

I would start with water changes and possibly run Detox .

 

[Dreamkeeper]

bought tank used, I have been running carbon, will try detox. all pumps/ electrical are new.
Thanks

 

[Randy Holmes-Farley]

FWIW, my copper was higher than that (~ 13 ppb) in what I consider a perfectly fine reef tank. So I wouldn't worry about it. Not sure where it was coming from in my case, but my best guess is foods.

 

[Dreamkeeper]

I also noticed that all my Fe- group results all reported zero, which I find strange as I run GFO and purposely direct reactor output into a filter sock to catch any fine particles and have noticed the clear tubing is discolored from the iron. Is it possible an error in testing this group?
Randy, I understand you are not a proponent of Iodine dosing, so you would not worry @ Iodine level of 8.80 ug/l?
Thanks in advance!

 

[Randy Holmes-Farley]

FWIW, Triton cannot measure iron down to the the NSW level, so you may have some from dissolving GFO/iron and just do not detect it.

No, I don't think that iodine dosing is useful for most folks, and if I had that result (waiting on mine to be processed), I wouldn't worry about it.