i happen to notice last night that, after all tank lights were to be off that all bulbs on the reefbreeder v2+ were flashing steady. at a very low light volume. so low that if i were to set a bulb at 1%, 1% is even higher than what they flash at. its very dim, but like i said, they are all flashing. However, now that lights are on, and in the custom mode light schedule, they light as they should. no flickering, all diodes are lit as they should be, etc. even the ones that are programmed to 0, are off and not flickering. its all good when operating within a programmed light schedule, but when lights are supposed to be 0, they all flicker at steady intervals (flash every second). if i use the remote to turn the schedule off manually, they all flicker.
Any thoughts? or any other experience with this.
I am lucky enough to have another reefbreeder light here to see if it is a setting within the remote, and it doesnt seem to be that. the secondary light, when its supposed to be off, its off.
Any thoughts? or any other experience with this.
I am lucky enough to have another reefbreeder light here to see if it is a setting within the remote, and it doesnt seem to be that. the secondary light, when its supposed to be off, its off.