Apex Temp Probe for use on PM2 & 3dPrinted Strainer(red) for 1.5" PVC

[ellisz]

I am looking for the following:

Apex Temp Probe for use on PM2

3dPrinted Strainer(red) for 1.5" PVC. Pump is external and 1.5" pipe with 45 fitting is in the sump. A strainer that will slip fit into the fitting would be all that is needed.

Thanks

 

[Shirak]

I am looking for the following:

Apex Temp Probe for use on PM2

3dPrinted Strainer(red) for 1.5" PVC. Pump is external and 1.5" pipe with 45 fitting is in the sump. A strainer that will slip fit into the fitting would be all that is needed.

Thanks

I could design a slip in strainer but why not just get the 11/2 slip strainer from BRS? https://www.bulkreefsupply.com/bulkhead-overflow-strainers.html

 

[ellisz]

Thanks. I was not using the right words for my searches and never saw that one. I found a couple of others now. A Red one would be cool but not if it is worth the effort.

Just saw that Plastidip is reef safe ... Did not know that either!

 

[Shirak]

Yes I have used plastidip on stainless temperature probes. I could make one in red ABS similar to the BRS one but would take time to design and print so not sure it's worth the extra $ to you.