I like adding a lot of redundancy in case something fails. Are you able to run two high/low water sensors for an ato pump on the hydros? I currently have the two for my atk, then another lower sensor that I use to trigger the ato again and if it stays above water for 5 minutes it also shuts off the return pump, skimmer, uv, uv pump, and triggers alerts. I also have a 2nd high sensir that also tells the ato pump to shut off along with the skimmer so the skimmer does not overflow. I don't consider this conplex and enjoy the customization it allows. Does the hydros allow the same or better setup?If you need your users to write code to do a task in 2024 you've messed up bad. Hot take I know.