Forget the logic for now, just see if the switch is working. On your dash, can you see Sw2 switch open and close when you manually activate it?No it's not that I really think my switch is wrong
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Forget the logic for now, just see if the switch is working. On your dash, can you see Sw2 switch open and close when you manually activate it?No it's not that I really think my switch is wrong
Can you share your settings for display tank and what switch are you using? Can put switch inside overflow so I can stop return pump when the water gets to high?-sump level low (so the return doesn't run dry)
-display level high (to keep the floor dry)
-cabinet light (magnet switch to turn the lights on under the stand when the door is opened)
-skim locker (float switch to kill the skimmer and text me when it's full)
-flexible float switch (i put these in containers i'm filling up so when it trips it shuts the utility pump off...to keep the floor dry)
-i hooked up different switchees buttons and stuff to trigger different lights and feed modes too using virtual outlets as timers and control if then statments
-sump level low (so the return doesn't run dry)
-display level high (to keep the floor dry)
-cabinet light (magnet switch to turn the lights on under the stand when the door is opened)
-skim locker (float switch to kill the skimmer and text me when it's full)
-flexible float switch (i put these in containers i'm filling up so when it trips it shuts the utility pump off...to keep the floor dry)
-i hooked up different switchees buttons and stuff to trigger different lights and feed modes too using virtual outlets as timers and control if then statments
So if your Skimmer or return pump is ran off of the variable speed plug how would you program it to run at say 10% when the skimate locker is full and when the high sump sensor is closed?
Thank you I figured this was the case I was hopeing it was something easier I to watched the coral vue video as I just hooked my varios speed port up
Can you share your settings for display tank and what switch are you using? Can put switch inside overflow so I can stop return pump when the water gets to high?
Can you share the magnet switch you used?
I use virtual outlets to trigger everything based on the switch and it makes it easier to comprehend.
My return pump is a jebao dc6000, and it goes off the triggered switches.
Here’s a pic of the float in my overflow.