wavemakers

  1. Volv

    Too much water movement for my gobies?

    Hello, So I'm really confused aboud flow now. I've read everywhere that it's very necessary in a reef tank and it should be strong, etc etc. Now, I decided to move everything on from my 10 gal nano and make properly equipped 30 gal. I got Tunze nano skimmer on the right back, along with 50watt...
  2. italquam

    Hydor Koralia Wavemaker and (2) Koralia 3250 gph Setup

    I am selling a brand new Hydor Koralia Wavemaker Dual Pump Controller and (2) Hydor Koralia Pumps 3250 gph. (These are the big boy Wavemakers , lot of water movement) Hydor Koralia Magnum 8 These are all brand new in original boxes . I got them for a build I never did , so I am looking to move...
  3. ReeferMadness01

    4X MP40 mobius ready.

    4 MP40s, each has an extra wetside and controller mount. Buy all for $300 each or singles for $350 each. FREE SHIPPING
  4. Msmith2813

    Tennessee Powerheads Drygoods Nero 5 FS

    I have a brand new in box Nero 5. It has been sitting around as the backup and wants to see some action. So on the market it goes. Asking $200 shipped or best offer
  5. Tygris88

    New To Reefing - Looking for Advice for Basic Equipment Requirements

    Hi Fellow Reefers, I am new to the reefing game and I have just recently purchased a second-hand red sea peninsula 650. I am wondering what equipment I would need at the very least to get a couple of clowns in there to get me started until I start investing over time. I am assuming I don't...
  6. attiland

    Jebao Wave Maker with Wifi SLW-10M and RW slave?

    Hi all, I need to replace one of my jabeo SW-2 as it tend not to start after I stop it. It takes some fiddle before it starts again. I was thinking to get a new Jebao SLW-10M or SLW-20M as replacement. The big question is if the master and slave connection would work between the different...
  7. MichaelP121579

    Tennessee Powerheads Mp10qd Mobius

    I bought this mp10qd about 5 weeks ago, it sat in box for 2 more weeks so its ran about 3 weeks. Nothing is wrong with it. I love the way they look, but I hate the fact you can't get any direction of flow other than straight. So I order a Nero3. The mp10qd will be pulled from tank and cleaned up...
  8. jacobreynolds6883

    Powerhead Placement

    Some guidance needed! Since starting up this 90g I have struggled with getting enough flow at the bottom of the tank to keep detritus in water column. The attached pictures show my powerhead placements. The one on the right is an eflux 2100gph turned up to 80%, large powerhead on left is a...
Back
Top