anteater
New Member
I'm new to the hobby and initially tried putting a Synergy Reef 16" V1 into a 40G breeder I drilled. Unfortunately I couldn't get a 100% watertight seal so went with another approach, so selling off the Synergy Reef + 40B.
Includes:
* Synergy Reef 16" V1 and original box and parts (https://synergyreef.com/shadow-over...ctions-how-to-install-the-shadow-overflow-v1/)
* All shown PVC pipe and fittings
* Drilled 40G breeder (from Petco), with rear and left side painted with Acrylic Latex (likely removable if needed)
* 65mm hole saw
I'm sure someone with more time and patience can get this to work. The box/aquarium seal seemed fine but over ~24 hours a few drops of water would get out from both gaskets on the back of the aquarium glass - see attached photos.
Originally paid $160 for overflow, $40 for 40B, and $10 for hole saw.
I want it out of my garage - name your price!
Located intersection of I-79 and I-76
Includes:
* Synergy Reef 16" V1 and original box and parts (https://synergyreef.com/shadow-over...ctions-how-to-install-the-shadow-overflow-v1/)
* All shown PVC pipe and fittings
* Drilled 40G breeder (from Petco), with rear and left side painted with Acrylic Latex (likely removable if needed)
* 65mm hole saw
I'm sure someone with more time and patience can get this to work. The box/aquarium seal seemed fine but over ~24 hours a few drops of water would get out from both gaskets on the back of the aquarium glass - see attached photos.
Originally paid $160 for overflow, $40 for 40B, and $10 for hole saw.
I want it out of my garage - name your price!
Located intersection of I-79 and I-76
