DIY powerhead/wave pump controler

ShakeyGizzard

RedNeck Member
View Badges
Joined
Sep 18, 2023
Messages
604
Reaction score
1,185
Location
West Central Georgia
Rating - 0%
0   0   0
I ran this on my freshwater tanks for years, don't know if its used for saltwater but I don't see why not. If you run your powerheads at a steady speed, this can save a few bucks when you have one go bad. You will not have to purchase the complete powerhead and control assembly, just the powerhead. It will take some knowledge of wiring and connector assembly. This is composed of a 12 or 24 volt power supply, and a voltage controller. I don't recommend using an old power brick because most are amperage restricted. Depends on your powerhead amp draw, you can run 2 to 4 power heads on this.

Power supply: 15 to 30 amp , 12 and 24 volt. $23
12 VOLT POWER SUPPLY.jpg


Voltage controller: 30 amp speed controller. will work with 12 or 24 volt. $10

SPEED CONTROLLER.jpg


When i mounted my speed controller, I drilled a hole in the side of the mounting cover for the knob. I used my voltmeter to measure voltage at lowest setting and highest to mark the cover.

On a side note this can be used to control a countless number of products economically.

12 volt power supply from amazon:
ALITOVE AC 110V/220V to DC 12V 30A 360W Universal
Regulated Switching Power Supply Transformer Adapter
LED Driver for LED Strip, CCTV Camera System, Radio

24 volt power supply from amazon: ( as example, there are higher amperage availible)

ALITOVE DC 24V 15A 360W Power Supply Universal Regulated
Switching Transformer Adapter LED Driver 110V/220V AC
Input for LED Strip CCTV Radio

Speed controller from amazon:
RioRand PWM DC Motor Speed Controller
Switch Control 7-70V 30A Fuse (RRLSKJAASSSSSSS)
 

Borat

Valuable Member
View Badges
Joined
Apr 4, 2021
Messages
1,507
Reaction score
1,748
Location
United Kingdom
Rating - 0%
0   0   0
This is a good idea - except that some manufacturers (Jebao MLW) don't sell just the powerhead, you have to buy the controller (which is not expensive)..

I don't run my powerheads in constant mode - so I need a sine wave controller... However all my DIY devices take as input 12v (1x alk monitor with 3 heads, and 4 dosers each with 3 heads) - so I run them off a single high AMP 12v PSU - this saves space, complexity and cabling issues.
 

Just grow it: Have you ever added CO2 to your reef tank?

  • I currently use a CO2 with my reef tank.

    Votes: 6 7.4%
  • I don’t currently use CO2 with my reef tank, but I have in the past.

    Votes: 3 3.7%
  • I have never used CO2 with my reef tank, but I plan to in the future.

    Votes: 5 6.2%
  • I have never used CO2 with my reef tank and have no plans to in the future.

    Votes: 63 77.8%
  • Other.

    Votes: 4 4.9%
Back
Top