tbd 100

[tbdh20]

After the debacle I had, trying to upgrade my current 60 cube, I finally decided to pull the trigger on a cad lights 100g.

On Hand.
-Zero Edge series 7
-Eco tech QD40
- Eheim ATO
- Eheim compact return
-Old school 8 bulb tek light w/ reefbrite.

Pics to follow.

 

[LILBUDDHA]

Snap ,Crackle ,Pop ..it's on !.
4 x 2 feet of fun . I can't wait to be there, when water hits it .

 

[tbdh20]

Current tank a 60 cube.

 

[tbdh20]

New sump ato and return.

 

[tbdh20]

Tek and reefbrite that will need a little modification.

 

[tbdh20]

The skimmer I had on hand and planned on using. It's a tight fit in the sump, will be replaced. RLSS R8i.

 

[SantaMonicaHelp]

Very nice! Can't wait to see it all put together!
P.S. Looks like somebody works out haha. Nice weights!

-Sal

 

[tbdh20]

Thanks Sal!
I can't wait either, this will be the third attempt to upgrade. Last winter/spring, received two tanks with issues and decided on a different route. Currently waiting on a shipping conformation.

 

[revhtree]

Following!

 

[tbdh20]

The tank arrived today!







So ready to get this build off the ground.

 

[tbdh20]

More.

 

[tbdh20]

A long time friend Lilbuddha drove down and gave me a hand with the new build!

Buddha teaching my wife why corals are so expensive.

 

[tbdh20]

New tank in place. Cloudy and a ton to finish up tomorrow but happy with the progress!

 

[tbdh20]

Current equipment list.
Cad 100 artisan II
ZeroEdge series 7 26"
Eheim compact 3000
Via Aqua 150W
Tunze osmolator 3155
SWC BMK 150
Tek 8 bulb T5, only running 6
Reefbrite 48" tech blue
Vortech MP40QD, Tunze 6045 6025
DA RK lite 2x PC4
Dosers 2x BRS

Future upgrades.
Skimmer tba
1 additional BRS dosing pump
1 additional MP40QD
Neptune apex controller

 

[tbdh20]

Tek light pre face lift.

 

[tbdh20]

Temporary cabinet setup till the new controller set up is ordered. It'll tidy up a bit and afford much need space. A few odds and ends need attention, ato, dosers, etc. just ran out of time today.

 

[Moonlightreef]

wow amazing . im defiantly following this build

 

[tbdh20]

wow amazing . im defiantly following this build

Thank you! Moonlightreef

 

[LILBUDDHA]

Ha... The only weights I have seen you lift were 12 0z 'r's .
It looks like you touched up the areas where the sump was sliding around in the cabinet scratching it up .
Did u find the shelves yesterday ?

 

[tbdh20]

Ha... The only weights I have seen you lift were 12 0z 'r's .
It looks like you touched up the areas where the sump was sliding around in the cabinet scratching it up .
Did u find the shelves yesterday ?

Haha.. and a occasional 24 oz. I did touch up a bit and finished painting the fixture. Also found temp shelving that is being obscured by the ato and dosing jugs atm. Later today hope finish up the cabinet and put the fixture together.