- Joined
- Sep 15, 2013
- Messages
- 439
- Reaction score
- 104
- Location
- SoCal
- What state or country do you live in
- California
Hello all I recently have been dealing with an issue in my Metal Halide Lighting system. A few months back the original ballast I had running the lights for 10+ years failed I took it apart and found some of the internals melted. Threw it away and bought a slightly used Lumatek 250/400w dimmable ballast from another user on this platform. From my initial research it should work perfectly fine with my setup.
I also bought a new Pheonix 14k HQI bulb to go with the new ballast. Everything worked fine for about 2 weeks & then my problems began. I am now dealing with an annoying inconsistency in the firing of the bulb, sometimes it turns on fine other times it does not fire at all. In the event that it does not fire occasionally if I disconnected everything and waited 30 minutes to a few hours before plugging everything back in and plugging it into the wall it would fire for the remainder of that day but then like clockwork the next morning when I go to plug it into the wall it does not fire. Sometimes it takes multiple days before it will fire again even with the above steps.
This is when I decided to open the fixture / reflector itself to see if there was any damage inside. I noticed the wires that connect the bulb housing to the ballast had became corroded and the insulation on some of the wires had became brittle and cracked away. I removed the affected areas and re-wired the fixture the way it was originally. Plugged everything back into the lumatek ballast and gave it power and it started up like normal. Figured the damage had been dealt with and it was now fine however this morning when I went to turn the lights on the same thing happened as has been occurring and the bulb did not fire this time around.
I went through the check list unplugged everything, attempted to reset the ballast, reopened the housing & checked connections, everything looked fine still. I’m at a loss now as it is still not firing despite all my efforts. Any help or advice would be appreciated I can post pictures of the ballast and fixture if needed
I also bought a new Pheonix 14k HQI bulb to go with the new ballast. Everything worked fine for about 2 weeks & then my problems began. I am now dealing with an annoying inconsistency in the firing of the bulb, sometimes it turns on fine other times it does not fire at all. In the event that it does not fire occasionally if I disconnected everything and waited 30 minutes to a few hours before plugging everything back in and plugging it into the wall it would fire for the remainder of that day but then like clockwork the next morning when I go to plug it into the wall it does not fire. Sometimes it takes multiple days before it will fire again even with the above steps.
This is when I decided to open the fixture / reflector itself to see if there was any damage inside. I noticed the wires that connect the bulb housing to the ballast had became corroded and the insulation on some of the wires had became brittle and cracked away. I removed the affected areas and re-wired the fixture the way it was originally. Plugged everything back into the lumatek ballast and gave it power and it started up like normal. Figured the damage had been dealt with and it was now fine however this morning when I went to turn the lights on the same thing happened as has been occurring and the bulb did not fire this time around.
I went through the check list unplugged everything, attempted to reset the ballast, reopened the housing & checked connections, everything looked fine still. I’m at a loss now as it is still not firing despite all my efforts. Any help or advice would be appreciated I can post pictures of the ballast and fixture if needed
