300xl Build

OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
I picked up one of these drop in refugium's. it also comes with a small pump when I placed it in the sump about a quarter of fuge is out of the water and when the pump runs to close to surface. doesn't circulate good enough and would be a salt creep mess

354103593_1007694913998080_4293905247921424100_n.jpg


353170309_291392009978181_1177431548712181294_n.jpg

so here I decided to drill another hole lower down for the pump
354498072_610794194489469_8900485372867063402_n.jpg
I'm thinking this should help me tumble the cheato nicely without the pump splashing making a salt creep mess
354287253_6753426111390298_4447334189275491585_n.jpg

FYI
I have the Gen 1 redsea sump that I modified to fit redsea roller mat. the divider for the fuge is lost when you remove the filter socks
 
OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
Updated picture of sump with new light. Kissel H80. I had the Tunze light on before but was just too long to fit in the small space I had left

370221095_161600070313128_6985724075529521183_n.jpg
 
OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
I few pictures of some of the corals I have in the tank

IMG_20231104_194321866.jpg
IMG_20231104_194240348.jpg
IMG_20231104_194244695.jpg
IMG_20231104_194254890.jpg
IMG_20231104_194342707.jpg
 

Attachments

  • 399621998_7181729618527691_518545085831109247_n.mp4
    5 MB
OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
The PH in my tank rarely spent much time above 8.0 so I'm trying a CO scrubber to see how much of a change it will make

IMG_20231104_193711551.jpg
IMG_20231104_193735360.jpg
IMG_20231104_193724464.jpg
 
OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
Saturday Nov-4 my Reefmat drive motor quit working. used the app to sent massage mainly just to see what they will tell me. I know these motors have issues and already placed and order to get one this week
 
OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
Needed to replace the drive motor for my roller mat. motor failed on Saturday and ordered new part Monday it arrived Friday. Toke me about 15 minutes total time to replace motor and install sub-assembly back onto base. No need to reprogram unit just motor change and then go to app and hit resume.
While I was waiting on motor every time I passed the tank I would hand turn the wheel a little to keep filter working
369994543_307636408887462_2724772869399968745_n.jpg
371541492_877177017364626_5123308203642918116_n.jpg
369161220_663029242323203_4952569640345592784_n.jpg
 
OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
An update from December 21 and not a good one.

Ok, at about 4am my wife woke me up and told me she smelled smoke, after making lap around the house and no fire. we found the strongest smell in the room with the tank. when I open the cabinet doors the DOS doser for the auto water change started running and then the breaker popped. After further investigating I found the inlet (new water) water line for the auto water change had come off and every time the doser started the new water was just dropped down and low and behold the power brick for the light was getting a little spray every time it ran. I unplugged from the wall and disconnected opposite end and checked the AC end and power brick were damaged beyond use. Next reset breaker and everything was back up and running and back to bed.

After waking up in the morning I reattached the line that had come of and plugged the Doser back in. I checked the rest of the connections. all were good.
I sent a ticket to Neptune requesting replacements parts. The next day I called and if I remember right they were closed for the holidays. called again the 27th the individual updated ticket and needed to check inventory to see if they have any. After more calls and on January 2nd I was able to pay for parts. Also during this time I was going to be driving a couple of horses to Florida for the winter show season. Left on Friday the 5th and at that time parts have not arrived. Drove to Florida and ran around to help get everything setup for them to ride and take care of the horse. On one of these days the Apec jr sent a message that temp was high. Contacted house sitter to take a look but was going to be a bit before she would get to the house as the temp was continuing to rise. just had heater unplugged. Arrived back home on the 15th and went straight to work, when arrived home I replaced the inkbird controller. The heaters them self were still ok. The 16th called Neptune and for what ever reason parts were never shipped and they said they would find out what was going on and call me back. nuptune called back and said they contacted BRS and they would ship the parts out for the light.

After all of this I lost a Torch and a small single head hammer with another octo not looking very good. all three of these I added to tank one week before the light failure. The rest of the corals have been in the tank for some time and recovered just fine. The new additions couldn't handle the issues.
 
OP
OP
Bob E

Bob E

Active Member
View Badges
Joined
Mar 21, 2016
Messages
337
Reaction score
206
Location
Minnesota
Rating - 0%
0   0   0
A hitch hiker from last year must have laid some eggs. this is the first time I seen one of them since I first caught the adult april last year
a baby sea slug or bubble snail
I guess this means I likely have many roaming the tank


432260900_786423319542089_997723349629529680_n.jpg
432440734_1415346242447043_9131880759167627539_n.jpg
428485595_927745868803337_6536963689789553597_n.jpg
 

Going off the ledge: Would you be interested in a drop off aquarium?

  • I currently have a drop off style aquarium

    Votes: 2 1.1%
  • I don’t currently have a drop off style aquarium, but I have in the past.

    Votes: 3 1.7%
  • I haven’t had a drop off style aquarium, but I plan to in the future.

    Votes: 26 14.9%
  • I am interested in a drop off style aquarium, but have no plans to add one in the future.

    Votes: 84 48.3%
  • I am not interested in a drop off style aquarium.

    Votes: 54 31.0%
  • Other.

    Votes: 5 2.9%
Back
Top