I have taken the plunge and joined the forum so hi the UK.
I have found lots of useful information on 3D printing on this forums but can’t see to find the answer for this.
what finish if any do people use on their prints?
I have also read that a lot of 3D printers use acetone vapour to clean up their prints is their a safe alternative? I find that my prints come out ok ish but with the odd bit of stringing will need to be tidied up
I’m new to 3D printing but want to make sure everything is safe for the mixed reef tank.
Any tips and tricks would be useful. Great forum already reading bits on photography etc.
I have found lots of useful information on 3D printing on this forums but can’t see to find the answer for this.
what finish if any do people use on their prints?
I have also read that a lot of 3D printers use acetone vapour to clean up their prints is their a safe alternative? I find that my prints come out ok ish but with the odd bit of stringing will need to be tidied up
I’m new to 3D printing but want to make sure everything is safe for the mixed reef tank.
Any tips and tricks would be useful. Great forum already reading bits on photography etc.