if i wanted to make stand for a 40 breeder display, but also house a 40 breeder sump how do I do that? I am designing one, but i have the top right, however I want the sump to sit inside the bottom 2x4's (almost like a tub), but in order to do that, that section needs to be 18.5" wide. If I do that, then the top is too wide, and the breeder would fall through. The only thing I can think of (and I'm not an engineer or a carpenter) is to use 3/4" plywood as a tabletop, glued/screwed into the top part of the frame.
A) would this work?
B) I think if it would work, I would need to add a center brace on the top frame to add support to the 3/4" ply right?
A) would this work?
B) I think if it would work, I would need to add a center brace on the top frame to add support to the 3/4" ply right?