6105 eco + hub controller

[areefer01]

HI - quick question if anyone has the answer.

There is a hat icon to the right of the ramp slider and I am curious how this works (first image). If I click on that icon a window is displayed that allows some fine tuning or what I think to be more control. The question is if I hit the icon that to me seems like "play" (second image, green box) it increments the ramp timer. I am not sure if it is by the number set or defaults to 1 second but when I go back to the main hub mention (first image again) the ramp slider is incrementing in real time.

This seems like a nice feature to make a rolling ramp up or so I thought. I checked back after a couple of hours and I do not see the ramp slider moving in real time so I'm not sure how this works. Maybe you hit the play or icon that looks like play to test it out and then after X minutes it goes back to default?

Love the pumps but a bit of a learning curve trying to figure out how the options work in relationship to linked (pairs) and unlinked pumps and if there is a reverse mode (push/pull) vs linked and sync.

The invert and day sliders would also be nice to know how they work in relationship to link or in general.

Thanks.

 

[rvitko]

It is supposed to be a knob, play advances 1 ms and the 3 seconds is how often, so basically in this scenario 501, 3 seconds later 502, etc, once you leave this submenu, it is set, this is for setting and not a continuous running function, it lets you sit back and watch the result and save it.

 

[rvitko]

Invert only works when you pair 2 pumps and you can make one run the opposite of the other, so if you have a 30-100 pulse, one pump does 30 when the other does 100. Day cycle creates a calm night mode, pulsing stops, the pump runs at one constant speed.

 

[areefer01]

It is supposed to be a knob, play advances 1 ms and the 3 seconds is how often, so basically in this scenario 501, 3 seconds later 502, etc, once you leave this submenu, it is set, this is for setting and not a continuous running function, it lets you sit back and watch the result and save it.

Thank you. I thought it was continuous.

Invert only works when you pair 2 pumps and you can make one run the opposite of the other, so if you have a 30-100 pulse, one pump does 30 when the other does 100. Day cycle creates a calm night mode, pulsing stops, the pump runs at one constant speed.

Thank you. They are linked together and see this. I think for me the confusion was knowing if it was actually on, or off, with regards to the invert slider. I am assuming left is off, right is on. Same with daylight.

Is there a setting menu with daylight/night mode?