Acclimating newly purchased frags

Reefnjunkie

Acropora Junkie
View Badges
Joined
Aug 1, 2009
Messages
2,075
Reaction score
1,395
Location
Portland,OR
What state or country do you live in
Oregon
Rating - 100%
1   0   0
I'm curious what the general consensus is for those who buy SPS frags on how you acclimate your new additions?

I used to drip my frags years ago but from advise I received from more than one source I stopped. I used to think it was the best way to go but was told its better to float them to temp and drop them in since they are already stressed from shipping and dripping wasn't the best practice.

just curious what others think or do
 
I put a couple of inches of tank water in a Tupperware pan and place the open frag bags upright. I use a baster and slowly put tank water in each bag, then pour most out when full and repeat until the water in the bag is largely tank water and at the correct temp. This process can take anywhere from 20minutes to a couple of hours depending on the time of year/temp in frag bags. I then dip in tank water with Bayer and rinse. They then go in the DT or QT.
 
I take them out of the bag and put them in the tank. I have as good if not better luck doing it this way than anything else I've tried in over 20 years of keeping reef tanks.
 
only float, dip, then drop, nothing else. Have been doing this for the past 2 years and haven't seen any issue. Some didn't survive but I don't think that is because of the acclimation.
 
Qt if you can float and put in. The only way to know if they are pest free is to qt and watch to make sure they are pest free.
 
Dip with Bayer in the water they came in. Meanwhile, pull some tank water and put in another container next to it on the counter. After 20 or so minutes in Bayer dip, rinse coral in the now closer to room temperature tank water in the separate container. Put it in the frag tank - usually. If I am very confident in the former owner, have inspected it with readers and a magnifying glass and the piece is one that I simply cannot take the chance of losing (like Dustin's Deepwater for example) I will put in the display after the dip and rinse. Rarely. Otherwise new corals live in the frag tank for a while and get 2 more dips before hitting the display.
 
I float to temp. Add dt water and bag water along with frag in 1 gallon container and slowly add enough dt water to make 1 gallon. Dip with coral Rx. Rinse in dt water and add to qt tank for at least 4 weeks before adding to dt tank.
 
Seems like most people temp acclimate by floating , then dip and drop in without any sort of drip or water mixing
 
I float bag for temp. Then put frag and bag water in container then add tank water slowly over 10 minutes then Bayer dip. Then rinse. Then light acclimation for a couple weeks.
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 8 23.5%
  • Powerheads or wavemakers

    Votes: 3 8.8%
  • Sump or rear filtration chambers

    Votes: 5 14.7%
  • Skimmer or other filtration equipment

    Votes: 2 5.9%
  • Overflow or plumbing

    Votes: 7 20.6%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 8 23.5%
  • Other—tell us what I missed

    Votes: 1 2.9%
Back
Top
Home
Post thread…
Market
What's new