Adding a clarisea (sk 3000 or sk 5000) to a trigger sump 26

  • Thread starter Thread starter Ayrity
  • Start date Start date
  • Tagged users Tagged users None

Ayrity

Community Member
View Badges
Joined
Jan 25, 2019
Messages
69
Reaction score
47
Location
Tampa FL
What state or country do you live in
Florida
Rating - 0%
0   0   0
Hey all, I want to add a clarisea to my sump, but as you can see, I'm not sure if I have room. How would you go about doing this? I read you can hang them off the sides of a sump, I assume it has to be inside the sump not hung off the outside right? I dont think I can cut the filter sock area out of this sump, the rim around that area is all solidly fused to the rest of the sump trim. Most of that first chamber is taken up by the skimmer. Any ideas? Thanks!
20191130_050847.jpg
20191130_050854.jpg
20191130_050917.jpg
 
If you can move the skimmer to the center section it would probably fit.
It does have to be in water & sizing is done by flow rates.
The drain line hooks up to the unit & the unit must be removed to change the roll.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new