Advice on Calcium Reactor Settings

  • Thread starter Thread starter CDavmd
  • Start date Start date
  • Tagged users Tagged users None

CDavmd

AstroReefer
View Badges
Joined
Sep 18, 2017
Messages
864
Reaction score
1,312
Location
Massachusetts
What state or country do you live in
Massachusetts
Rating - 0%
0   0   0
Hi all, I recently added a Geo 612 calcium reactor to my system. I was previously dosing ATI essentials Pro but it was getting to be a hassle as the consumption was increasing significantly.

I pegged my reactor's pH at 6.5 and it essential fluctuates from 6.49 to 6.51 I'm using reborn and about 10% Remag.

Screen Shot 2019-11-17 at 6.10.06 AM.png


The effluent dKH has measured at 31dKH and I'm using the Carbon Doser to bubble CO2 at about 15 bubbles per minute at a pressure of 12. I'm also using the Kamoer dosing pump and I'm running at about 10cc per minute which basically drips at about 1-2 drops per second.
My Alkalinity has been pretty stable with this setting for about a week.

Screen Shot 2019-11-17 at 6.15.41 AM.png


So my question- should I leave it as is? Is 10cc per minute to slow and lead to a clog at some point? I'm not sure if I should change the reactor pH to a higher setting and thereby increase the flow to a slow stream rather than the current drip rate.
Advice would be greatly appreciated.
 
If you are maintaining target levels then I see no reason to fiddle with it. Are you running the peri pump as push or pull? Latter may help to alleviate clogs. 6.5 seems a bit low for reborn. I run mine closer to 7.0. Just keep an eye out for overly melting media.
 
If you are maintaining target levels then I see no reason to fiddle with it. Are you running the peri pump as push or pull? Latter may help to alleviate clogs.
Thanks! I'm running pull and thus far no issues. The effluent is crystal clear.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new