AI Blade Heat Problem

  • Thread starter Thread starter Jesse571
  • Start date Start date
  • Tagged users Tagged users None

Jesse571

Active Member
View Badges
Joined
Dec 26, 2021
Messages
107
Reaction score
39
Location
Vancouver Island British Columbia Canada
What state or country do you live in
Canada
Rating - 0%
0   0   0
I just received 2 AI Blade 12” for my Nano Tank. I read good things about the Blades so bought then as soon as they came out. The problem is them come with these solid plastic “tank rests” that ends up covering almost all of the finned heat sink. Yes I know that the heat sinks are supposed to get hot as that is how they cool the light. But not this hot! I tried with and without the tank rests and it’s much cooler without them. The answer would be to have vented tank rests that I hope AI will supply or I will have to drill holes in my tank rests to cool which I really shouldn’t have to do.
IMG_2276.jpeg
 
It would benefit you to chop down the length on each one so the tank rest mount has just enough hold on the fixture in place without covering any heat sink capability.
Cut the side that holds the fixture since if you cut the other side it wont sit on the tank.

I would use a dremel with plastic cutting wheel.
 
Seems to me that those brackets shouldn't have been recommended for that size light. If it were me I would ditch those brackets and take advantage of the 8mm threaded bore holes on the sides and design/make a bracket that attaches to them.
 
It would benefit you to chop down the length on each one so the tank rest mount has just enough hold on the fixture in place without covering any heat sink capability.
Cut the side that holds the fixture since if you cut the other side it wont sit on the tank.

I would use a dremel with plastic cutting wheel.
Yes that sounds like a good idea. Thank you
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new