AI hydra 26hd light bracket.

Raising Reef.

Active Member
View Badges
Joined
Jul 24, 2018
Messages
115
Reaction score
212
What state or country do you live in
United Kingdom
Rating - 0%
0   0   0
I currently mount my light on a repurposed steel hanging rail like this.
53f7a310328d91a038c4c86f4379fd6a.jpg
0118d1284b57edaf27f99ab5dd18204c.jpg

I have a new tank build underway and I was thinking of mounting the light on a bracket a little sleeker and low profile for that high end look I’m using a eshopps overflow box so I have
3/4” of glass on the inside of the back panel
f768d8f2c04a1b90fb73bcf7ac68210e.jpg

And 2” on the back side
19418df91d74e4e06e9d3c1be14a6c11.jpg

Anybody know of a off the shelf bracket that will fit my hydra26hd and look nice that will fit with the overflow box.
Or do I have to make a custom bracket.
 
How about hanging the light?
 
Not an option for me I’m afraid
 
What did you end up doing?
 
I bought the same card flex arm, but the connector would not slide through the second rail of the heat sink. It was too tight. I have a hydra 26 hd.
 
I bought the same card flex arm, but the connector would not slide through the second rail of the heat sink. It was too tight. I have a hydra 26 hd.
I must admit I haven’t fitted the light to the bracket yet as I’m still using the light over my old tank until I cycle the new one but after reading this I may have to try it to make sure it fits ok.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 18 18.6%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.3%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.5%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.4%
  • I keep a backup of everything

    Votes: 25 25.8%
  • Other (Post in the comments)

    Votes: 7 7.2%
Back
Top
Home
Post thread…
Market
What's new