Apex changes sensor type

[rcpalmer1]

I have the ATK kit. It has been connected and working.
Here is the programming
Fallback OFF
Set OFF
If Swx6_1 OPEN Then ON
If Swx6_h CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF

Today I caught it just before my pump ran dry. Then I notice in Fusion it said I had a new tile flx 6_1 and my optical sensor slx 6_1 was missing. I have never had a flow sensor.

Why did Apex change my optical sensor to a flow sensor and how do I change it bac

 

[Reefin Aint Easy]

This is a common thing with the FMM/ATK. You have to deselect the box that say "auto detect sensor".

 

[Reefin Aint Easy]

Click on the little gear icon on the right of the FMM_6 module and it will open up the configuration screen. Then you will see the ports and what they are assigned. In there you will se the "auto detect sensor" box you can un check and change your sensor back from the flow sensor to the optical sensors.

 

[rcpalmer1]

Thanks. I am at work. I was able to unselect auto detect and change it back to optical. It should be close but is still showing opened. I will verify it when I get home.