Apex problem?

[ddaddy2420]

Any ideas what’s going on with my apex? It started making this clicking noise and it showed this red exclamation point in the pic. It wouldn’t allow anything to turn on and then it stopped and was fine.

 

[Perthegallon]

Did you try to go into the system settings and rebooting it is the power still on for the units at least?

 

[ddaddy2420]

I did reboot everything and it still did it for about 10 seconds then stopped and was fine. Is there a max voltage or amps the energy bar can take? Wondering if this chiller is too much for it??

 

[Perthegallon]

I did reboot everything and it still did it for about 10 seconds then stopped and was fine. Is there a max voltage or amps the energy bar can take? Wondering if this chiller is too much for it??

I think it’s somewhere of 1260 not 100% sure but I don’t think it would be a issue like that try to unplug it and replug it

 

[ddaddy2420]

Doing it again...

 

[Perthegallon]

Doing it again...

Sorry I can’t see that

 

[Perthegallon]

Worst comes to worst grab a power bar and switch your important stuff to that

 

[ddaddy2420]

Luckily I have an extra Kasa bar I just purchased I can swap to. Lights are flashing on the equipment hooked to the energy bar. Wondering if it’s dieing.

 

[Perthegallon]

Luckily I have an extra Kasa bar I just purchased I can swap to. Lights are flashing on the equipment hooked to the energy bar. Wondering if it’s dieing.

Yeah sorry about that it sucks im getting tired of my apex gear as well low quality for such high money

 

[ddaddy2420]

It actually sounds like it’s the other unit. The one with all the probes.

 

[Perthegallon]

It actually sounds like it’s the other unit. The one with all the probes.

The WiFi thing is cheap to replace I believe

 

[ddaddy2420]

So it finally showed in red ”eb_832-voltage error”

I unplugged everything from both units and it has stopped.

 

[Perthegallon]

So it finally showed in red ”eb_832-voltage error”

I unplugged everything from both units and it has stopped.

glad you got it working

 

[vetteguy53081]

Great - was a power overload. What you did is one step.
the other is to unplug everything and press the little yellow button behind the unit which is a reset.

 

[ddaddy2420]

Spoke too soon, started clicking again and that’s with nothing plugged in to energy bar.

 

[ddaddy2420]

Is the button behind the energy bar?

 

[ddaddy2420]

So yea it’s definitely the energy bar that is clicking, still doing it, should I hold the yellow button down?

 

[ddaddy2420]

Lol getting worse; everything lit up in red

 

[vetteguy53081]

Spoke too soon, started clicking again and that’s with nothing plugged in to energy bar.

try the reset button behind the EB832

 

[ddaddy2420]

I’m pressing it but it’s not helping. Power bar starts clicking like crazy shortly after I power it up.