Hi,
I am adding a kalkwasser system to my ATO routine. I ran this setup a long time ago but forgot the programming. As I recall, I had a delay on the ATO to prevent dosing a certain amount of time after the stirring pump cycled. To start, I am going to stir 4 times a day for 60 seconds.
Here's my Kalk programming:
Fallback OFF
OSC 000:00/001:00/359:00 Then ON
If pH > 8.50 Then OFF
Heres my ATO programming:
Fallback OFF
Set OFF
If ATO-Lo OPEN Then ON
If ATO-Hi CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
What statement do I add to prevent my ATO from triggering after a stir and how long should I wait? The outlet is names Kalk.
Thanks
I am adding a kalkwasser system to my ATO routine. I ran this setup a long time ago but forgot the programming. As I recall, I had a delay on the ATO to prevent dosing a certain amount of time after the stirring pump cycled. To start, I am going to stir 4 times a day for 60 seconds.
Here's my Kalk programming:
Fallback OFF
OSC 000:00/001:00/359:00 Then ON
If pH > 8.50 Then OFF
Heres my ATO programming:
Fallback OFF
Set OFF
If ATO-Lo OPEN Then ON
If ATO-Hi CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
What statement do I add to prevent my ATO from triggering after a stir and how long should I wait? The outlet is names Kalk.
Thanks