I have a new (1+ month) 170 tank with 50 gallon sump. I am considering adding an ATO to the setup. Our house has RO water at every sink and there is a bathroom sink on the other side of the common wall shared with the tank. I have a separate DI filter that will fit in the stand with the sump.
So here is my thought. Tell me if you think it will work or is a bad idea.
- T the RO line from the bathroom sink.
- add a Neptune solenoid after the T
- then the DI filter
- use the Neptune ATO kit (pump will not be used)
- low level optical sensor in sump return chamber
- high level optical sensor in sump return chamber
- Manual float as backup in sump return chamber
When low sensor exposed then open solenoid
When high sensor covered the close solenoid
This eliminates the pump and a separate tank to hold the top off water.
Thoughts?
So here is my thought. Tell me if you think it will work or is a bad idea.
- T the RO line from the bathroom sink.
- add a Neptune solenoid after the T
- then the DI filter
- use the Neptune ATO kit (pump will not be used)
- low level optical sensor in sump return chamber
- high level optical sensor in sump return chamber
- Manual float as backup in sump return chamber
When low sensor exposed then open solenoid
When high sensor covered the close solenoid
This eliminates the pump and a separate tank to hold the top off water.
Thoughts?