coloradoreefer94
Community Member
I have a Tunze Osmolator Nano 3 and I was wondering if there is a float switch/valve I can install as a safety measure to prevent any overflows incase the sensor gets stuck on in the future?
ATO float switch for Tunze nano?
- Thread starter coloradoreefer94
- Start date
- Tagged users None
Kooma
Well-Known Member
Not sure on your tunze, but on mine it will run the pump for 2 minutes and if it doesnt reach the desired level in that time, stops trying and does a pump "Bump" of power to tell me its either A. empty, or B. theres a clog.
Is this not standard with all tunze ATOs?
Here is what I have.
https://www.tunze.com/en/details/3152.000-osmolatorR-nano.html
Looks like yours should have this also.
if you are still worried, im sure you could hook it to a RODI float valve and adapt the line to 1/4" to block the pump if the water reaches the float.
Is this not standard with all tunze ATOs?
Here is what I have.
https://www.tunze.com/en/details/3152.000-osmolatorR-nano.html
Looks like yours should have this also.
if you are still worried, im sure you could hook it to a RODI float valve and adapt the line to 1/4" to block the pump if the water reaches the float.
Last edited:
Similar threads
