Baseline Calibration No3 - Mastertronic question(s)

[WhatCouldGoWrong71]

My reference solution has a no3 of 10. I put the sample tube in my bottle and my reading was 1.43. When I activated “baseline calibration” it allowed me to enter reference value and mastertronic value. So I went to enter 10.00 and 1.43 respectively. The system won’t allow me to enter any value unless it is 0.5 to 2.0. I’m lost, what am I doing wrong? When I put these values in it errors out with the message about 0.5 to 2.0 can only be used.

 

[Dan_P]

My reference solution has a no3 of 10. I put the sample tube in my bottle and my reading was 1.43. When I activated “baseline calibration” it allowed me to enter reference value and mastertronic value. So I went to enter 10.00 and 1.43 respectively. The system won’t allow me to enter any value unless it is 0.5 to 2.0. I’m lost, what am I doing wrong? When I put these values in it errors out with the message about 0.5 to 2.0 can only be used.

You have to dilute your reference to between 0.5 to 2.0.

 

[WhatCouldGoWrong71]

You have to dilute your reference to between 0.5 to 2.0.

Well, that was too easy. Lol.

 

[WhatCouldGoWrong71]

Thanks Dan.

 

[lillie17]

My reference solution has a no3 of 10. I put the sample tube in my bottle and my reading was 1.43. When I activated “baseline calibration” it allowed me to enter reference value and mastertronic value. So I went to enter 10.00 and 1.43 respectively. The system won’t allow me to enter any value unless it is 0.5 to 2.0. I’m lost, what am I doing wrong? When I put these values in it errors out with the message about 0.5 to 2.0 can only be used.

You have to dilute your reference to between 0.5 to 2.0.

Hi. I am having the same problem as above. How do I do this? Thanks

 

[Dan_P]

Hi. I am having the same problem as above. How do I do this? Thanks

To clarify, are you asking about diluting a reference standard?

 

[lillie17]

Hi. I am having the same problem as above. How do I do this? Thanks

To clarify, are you asking about diluting a reference standard?

Yes. Having the exact same problem at he is.

 

[WhatCouldGoWrong71]

Yes. Having the exact same problem at he is.

@lillie17 - now I get what you are asking in your PM. I’ll need to look tonight. I forgot about this. I’m fully over this waste of money. The only value I sort of trust that comes out of this point of sale is PO4.