Broke my RODI flow restrictor

[Extract1ng]

I got an older RODI system and went to upgrade the tubing as it was pretty old and cracked when bent. I tried to pull the waste water tubing out of the shark bite and it wasnt budging so I cut it and realized there was something in there.. which I learned was the flow restrictor. Should I get a new elbow and flow restrictor? (the flow restrictor isnt coming out without breaking it a think) It's a 75 GPD Aquafx Barracuda, but on there site they only sell 50 and 100GPD restrictors. Anyone know of a good one from amazon?

 

[Naekuh]

It says you want a 500 or 800 for 75GPD membrane

Sizing Flow Restrictors – Pure Water Products, LLC

A guide to determining the ideal flow restrictor for a reverse osmosis membrane, with charts.

www.purewaterproducts.com

100GPD uses the same flow restrictor, so i think you can be safe on the 800

I would personally just use a check valve 90 and put in a regular flow restrictor like these guys:


And not go the insert route your old one had.

 

[Extract1ng]

It says you want a 500 or 800 for 75GPD membrane

Sizing Flow Restrictors – Pure Water Products, LLC

A guide to determining the ideal flow restrictor for a reverse osmosis membrane, with charts.

www.purewaterproducts.com

100GPD uses the same flow restrictor, so i think you can be safe on the 800

I would personally just use a check valve 90 and put in a regular flow restrictor like these guys:


And not go the insert route your old one had.

Thank you!