Calcium help

KPollard1986

Community Member
View Badges
Joined
Feb 18, 2018
Messages
31
Reaction score
23
What state or country do you live in
New Jersey
Rating - 0%
0   0   0
I've been wondering lately as I have been testing my parameters, about my calcium levels. It stays pretty close to the 320-340 ppm area. My DKH is at 9. Could I be misreading my calcium test, or should I try and raise my calcium levels with dosing? Any feedback is greatly appreciated!
 
Couple questions.. What salt mix do you use ? What’s your salinity?What test kits are you using ? Have you tested magnesium levels?
Do you have a lot of coral ?sps?
you might be misreading . I have done that in the past but hard to say on this end.
If it is accurate I would dose to get your calcium up and stable.
 
Couple questions.. What salt mix do you use ? What’s your salinity?What test kits are you using ? Have you tested magnesium levels?
Do you have a lot of coral ?sps?
you might be misreading . I have done that in the past but hard to say on this end.
If it is accurate I would dose to get your calcium up and stable.
I'm using instant ocean sea salt, not reef crystals. Salinity is 1.025, and I have not tested magnesium. I only have one toadstool and a small hammer frag in a 55 gallon. I see coraline starting to take off though so I'm confused lol
 
No way to easily know if you Have a measurement issue ir a low calcium issue. Have you measured the new salt water? Raising it is a reasonable plan because even if it is already 400 ppm, raising that to 500 ppm is no problem.
 
No way to easily know if you Have a measurement issue ir a low calcium issue. Have you measured the new salt water? Raising it is a reasonable plan because even if it is already 400 ppm, raising that to 500 ppm is no problem.
So I made a new batch today and the new batch had a low calcium reading as well. Maybe just a bad batch? I'm not sure. Should I dose for now until salt batch is done, or just buy a new batch and re-test with that?
 
So I made a new batch today and the new batch had a low calcium reading as well. Maybe just a bad batch? I'm not sure. Should I dose for now until salt batch is done, or just buy a new batch and re-test with that?
Is there a way to get a measurement with a different kit or take it to the LFS to validate your results?
 
What salinity? That may be low, or the kit may be off. Less likely is an off batch if salt.
Salinity is 1.025. Everything else checks out fine, except magnesium, I don't have a test for that.
 
Is there a way to get a measurement with a different kit or take it to the LFS to validate your results?
I could buy a different kit, but I wont have it for a few days as my LFS is closed and petco doesn't carry anything except API. Also the reason I cant have my LFS test the water, closed for renovations.
 

TOP 10 Trending Threads

HOW DO YOU HANDLE HOLIDAY DECORATING AROUND YOUR REEF?

  • I decorate the tank or stand

    Votes: 1 2.9%
  • I decorate AROUND the tank or stand

    Votes: 4 11.8%
  • I add one small seasonal touch but keep it very basic

    Votes: 0 0.0%
  • I take a holiday photo, but don’t decorate the space

    Votes: 0 0.0%
  • I leave the reef area as it is

    Votes: 25 73.5%
  • We don’t decorate for the holidays

    Votes: 4 11.8%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new