Calcium Level

  • Thread starter Thread starter REEF911
  • Start date Start date
  • Tagged users Tagged users None

REEF911

Active Member
View Badges
Joined
Jul 3, 2012
Messages
148
Reaction score
34
Location
las vegas
Rating - 0%
0   0   0
My friends fish tank has a calcium level of 510 right now. His alk is at 10dkh and mag is at 1300. Salinity 1.023. It is a 60 gallon zoathid dominated tank with a few branching montiporas. I want to lower the calcium to around 420. My plan is to slightly over feed his tank for the next few days to cause some of the food to help lower the alk. Also the extra food will help to make the water more nutrient rich this feeding the zoas. Nitrates are 0 right now so I'm not worried about too high of nitrate from the slightly overfeeding. When alk begins to lower from the food breaking down in the water colum I plan to add more alk to counter the affect and help percipitate some of the excess calcium. I would like to bring his calc levels back to 420 without doing a water change but within doing the method described above. My question is, is there another way to lower calcium in a reef tank without affecting the alk. I can't go higher on the alk due to the fact that montis hate high alk.
 
[FONT=&quot]Are you sure of your readings? What kits are being used to check them with? What device is being used to check SG?
The uptake of Ca and Alk, by “stony†type coral, coralline algae, etc. in a reef system is 20 ppm Ca to 50 ppm(2.8dKH) Alk(CaCO3), which is a ratio of 2 pts Ca to 5 pts Alk (2:5). So, if you don't dose anything for a while, those numbers will come down to ~ 7.2dKH/460ppm, at which time you could add a little of your alk solution to get that number back up, and allow the Ca to drop to a level you're happy with, before starting your dosing regimen again. I would also suggest that your friend gets the SG up to 1.026, by using some make up water for top off instead of RO/DI.
[/FONT]
 
If those values (~550 and 10) are correct I recommend you do nothing. Just let both drop down.

It very well could be they will settle down to 400/8.

At that point I would do the diy two part to maintain those values.

This is really important if all your corals, corraline, hard macros, etc are doing just fine.

Don't mess with success.


my .02
 
Readings for alk calc and mag are being done with salifert test kit. Salinity is measured through a refracter. The levels have been this way for a long time. Zoas don't really mind because they don't use alk and mag as much or if at all. There are only two montis so letting the level drop down would take some time.
 
I have basically the same alk and calc readings as you except my magnesium is only 1080 which is why I think my coraline algae vanished. What effect does the high alk/calc have on corals? Should I quit using kalk and just do water changes?

Sent from my Nexus 7 using Tapatalk 2
 
What salt mix is he using? Some salt mixes have extremely elevated levels of calcium and alk. As long as the calcium is not precipitating out at that level I don't think it will cause any problems with it being that high. You may want to consider changing salt mixes if that is where the elevated levels are coming from.


Sent from my iPhone using Tapatalk
 
What salt mix is he using? Some salt mixes have extremely elevated levels of calcium and alk. As long as the calcium is not precipitating out at that level I don't think it will cause any problems with it being that high. You may want to consider changing salt mixes if that is where the elevated levels are coming from.

It sounds like they may be using Tropic Marin Pro Reef...but there are some others that are balanced crazy like that.

For a tank with no stony coral you definitely want to stick to a standard grade salt like Instant Ocean, regular Tropic Marin, etc.

I also have to say listen to BeaselBob....don't do anything about it (aside from switching salt). High Ca levels are rarely a problem when all else is well. Mine has been over 500ppm several times and even as high as 700ppm...if anything the corals were happier.

The worst likely outcome of having your Ca fairly high for a long time is that due to the heat and limited water flow, you might find some precipitation in the impeller well of any pumps running on the system. (It's invisible unless it's a heavy encrustation.) You might want to give all the pumps a good soak in white vinegar once "normal" numbers are restored, even if therere are no apparent problems.

-Matt
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 26 23.4%
  • I’d trust someone who knows my tank to choose

    Votes: 10 9.0%
  • I’d rather get a gift card and pick it myself

    Votes: 45 40.5%
  • I’d prefer gear or supplies instead

    Votes: 2 1.8%
  • Please don’t surprise me with livestock

    Votes: 28 25.2%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new