Can someone check my math for DIY Nickel

  • Thread starter Thread starter Biff0rz
  • Start date Start date
  • Tagged users Tagged users None

Biff0rz

Valuable Member
View Badges
Joined
Jul 9, 2020
Messages
2,412
Reaction score
1,454
Location
Michigan (SE)
Rating - 100%
2   0   0
I want to make a 2L of solution where 1 mL dosed into 100 L of aquarium water adds 1.0 µg/L Ni and then make a more concentrated one that is 2.0 µg/L.

I have the following formula from Randy-
https://www.reef2reef.com/threads/diy-trace-liquid-need-help-on-formula.1074716/#post-12881160
NiCl2 x 6 H2O (mw = 238 g/mole) is 24.7% nickel by weight.

1 g NiCl2 x 6 H2O /L is 247 mg Ni/L = ppm.

If you dose 1 mL of that to 100 liters of aquarium volume, the boost is 0.0025 mg/L or 2.5 ppb.


Convert to mg/L
1.0 μg/L × 100 L = 100 μg = 0.1 mg Ni

100 mg Ni / L
--------------------
0.247 (24.7%)
=
404.9mg NiCl2 x 6 H2O

Soooo for 2L, double that, or 809.8mg

Convert that to g, since I have a 0.01 scale, that is then 0.81g of NiCl2 x 6 H2O

And to make a 2x concentration, I would just add 1.62g to 2L of RODI.

Is the math, mathing?

Also, do I need to worry about mixing this in the house? How long would I need to mix it for?
 
Just give it a little longer, I'm sure @Randy Holmes-Farley will see this and have some comments for you soon 🙂

Good luck!
Thanks. I didn't do well in chemistry in HS or college...Never thought I'd use it again lol. Oh, how wrong was I?
 
Yes, the math is correct.

My original recipe is:

If you dose 1 mL of that to 100 liters of aquarium volume, the boost is 0.0025 mg/L or 2.5 ppb.

Note that 2.5 ppb = 2.5 ug/L

You want a solution that

1 mL dosed into 100 L of aquarium water adds 1.0 µg/L Ni

Your requested recipe is slightly less concentrated. Use 1/2.5 times as much. SO instead of

1 g NiCl2 x 6 H2O /L is 247 mg Ni/L = ppm.

you would use

0.4 g NiCl2 NiCl2 x 6 H2O dissolved in a liter of ro/di.

In your second request, you want one that is twice as strong, so you would add twice as much, or

0.8 g NiCl2 NiCl2 x 6 H2O dissolved in a liter of ro/di.

If you want to make 2 L of the 2 ug/L from 1 mL recipe, you double the amount to 1.6 g.
 
Yes, the math is correct.

My original recipe is:

If you dose 1 mL of that to 100 liters of aquarium volume, the boost is 0.0025 mg/L or 2.5 ppb.

Note that 2.5 ppb = 2.5 ug/L

You want a solution that

1 mL dosed into 100 L of aquarium water adds 1.0 µg/L Ni

Your requested recipe is slightly less concentrated. Use 1/2.5 times as much. SO instead of

1 g NiCl2 x 6 H2O /L is 247 mg Ni/L = ppm.

you would use

0.4 g NiCl2 NiCl2 x 6 H2O dissolved in a liter of ro/di.

In your second request, you want one that is twice as strong, so you would add twice as much, or

0.8 g NiCl2 NiCl2 x 6 H2O dissolved in a liter of ro/di.

If you want to make 2 L of the 2 ug/L from 1 mL recipe, you double the amount to 1.6 g.

Thanks! It looks like my 1.62g for a 2x concentration in 2L was good, whew! Also, it's kinda crazy that I only need 1.6g to make the solution I need. The smallest amount on amazon I found was 250g for $67. So essentially it's less than a penny to make (removing all the mixing tools, rodi, and whatnot), not to mention, this is kinda fun, haha. I read this about the toxicity-
Nickel(II) chloride hexahydrate is highly toxic, carcinogenic, and poses significant health risks. It is classified as toxic if swallowed or inhaled, can cause severe skin irritation/allergies, damage organs through prolonged exposure, and is harmful to the unborn child. It is also extremely toxic to aquatic life.
So I assume similar PPE is needed as when handling NaF? Also, it says its super toxic to aquatic life, but is that only in its pure form?


I can across a Facebook numinic to help with this. I'll try to find it. It really helped me do these conversations
sure! thanks!
 
I used this one, which was cheaper, but I got less.

https://a.co/d/06dS9bWC
I'd avoid breathing the dust, although mine was not at all dusty. Make sure to wash your hands afterwards (if you don't use gloves).
 
I want to make a 2L of solution where 1 mL dosed into 100 L of aquarium water adds 1.0 µg/L Ni and then make a more concentrated one that is 2.0 µg/L.

I have the following formula from Randy-
https://www.reef2reef.com/threads/diy-trace-liquid-need-help-on-formula.1074716/#post-12881160



Convert to mg/L
1.0 μg/L × 100 L = 100 μg = 0.1 mg Ni

100 mg Ni / L
--------------------
0.247 (24.7%)
=
404.9mg NiCl2 x 6 H2O

Soooo for 2L, double that, or 809.8mg

Convert that to g, since I have a 0.01 scale, that is then 0.81g of NiCl2 x 6 H2O

And to make a 2x concentration, I would just add 1.62g to 2L of RODI.

Is the math, mathing?

Also, do I need to worry about mixing this in the house? How long would I need to mix it for?

I think your math is mathing. I got the same numbers, so 0.81 g of NiCl2·6H2O in 2 L should give you the 1 µg/L stock, and 1.62 g is the correct 2x version. I’d dissolve it in a couple hundred milliliters of RODI first, stir until it’s completely clear, then top it up to the full 2 L. It usually dissolves pretty quickly, so a few minutes is enough if you’re stirring. I’d still wear gloves and avoid breathing the powder while weighing it, since nickel salts are not something I like handling casually. One thing I’ve learned with these trace solutions is that writing every conversion out step by step catches mistakes before they happen, and I found a pretty useful guide on https://mysupergeek.com/math-assignment-help-service while checking dilution calculations. It is aimed at math help, but the nice part is that it explains the logic behind unit conversions and concentration formulas instead of just giving an answer, which is surprisingly handy for reef chemistry too.

Your concentration math is a little off by a factor of 10. For 1.0 µg/L in 100 L from a 1 mL dose, the stock needs to contain 100 mg/L of elemental Ni. At 24.7% Ni by mass, that is about 405 mg/L of NiCl₂·6H₂O, so for 2 L the amount is about 810 mg, or 0.81 g. Your 1× calculation is therefore correct.

For the 2× stock, 1.62 g in 2 L is also correct. At 1 mL per 100 L, that stock would add about 2.0 µg/L Ni.

The one thing I would double check is the actual material you have. The 24.7% figure applies to anhydrous NiCl₂·6H₂O with the stated molecular weight of 238 g/mol, so I would make sure the chemical is actually the hexahydrate and reasonably pure. If it is a different hydrate or a product with less than 100% purity, the calculation changes.

For mixing, you do not need to aggressively stir it for a long time. I would use a clean container, add most of the RO/DI water first, dissolve the weighed salt completely, then bring it up to exactly 2.00 L. A few minutes of thorough mixing after everything is dissolved should be plenty. Nickel chloride is something I would handle carefully indoors: gloves and eye protection, avoid creating dust, and clean up any spills rather than treating it like an ordinary aquarium additive. I would also label the bottle clearly and keep it away from kids and pets.

One practical point: with a 0.01 g scale, your 0.81 g weighing has roughly ±0.01 g resolution, which is about a 1.2% difference, so the resulting stock should be plenty close for this purpose.
 
Your concentration math is a little off by a factor of 10. For 1.0 µg/L in 100 L from a 1 mL dose, the stock needs to contain 100 mg/L of elemental Ni. At 24.7% Ni by mass, that is about 405 mg/L of NiCl₂·6H₂O, so for 2 L the amount is about 810 mg, or 0.81 g. Your 1× calculation is therefore correct.

I'm having a hard time understanding what you are saying. Are you claiming my recipe is off, or that it is correct?

I do not believe my recipe is incorrect, and you get the same calculated amount???
 
I'm having a hard time understanding what you are saying. Are you claiming my recipe is off, or that it is correct?

I do not believe my recipe is incorrect, and you get the same calculated amount???
It's ai slop and the user should be banned. Just my opinion having worked in Ai for 2y now.
 
Your concentration math is a little off by a factor of 10. For 1.0 µg/L in 100 L from a 1 mL dose, the stock needs to contain 100 mg/L of elemental Ni. At 24.7% Ni by mass, that is about 405 mg/L of NiCl₂·6H₂O, so for 2 L the amount is about 810 mg, or 0.81 g. Your 1× calculation is therefore correct.

For the 2× stock, 1.62 g in 2 L is also correct. At 1 mL per 100 L, that stock would add about 2.0 µg/L Ni.

The one thing I would double check is the actual material you have. The 24.7% figure applies to anhydrous NiCl₂·6H₂O with the stated molecular weight of 238 g/mol, so I would make sure the chemical is actually the hexahydrate and reasonably pure. If it is a different hydrate or a product with less than 100% purity, the calculation changes.

For mixing, you do not need to aggressively stir it for a long time. I would use a clean container, add most of the RO/DI water first, dissolve the weighed salt completely, then bring it up to exactly 2.00 L. A few minutes of thorough mixing after everything is dissolved should be plenty. Nickel chloride is something I would handle carefully indoors: gloves and eye protection, avoid creating dust, and clean up any spills rather than treating it like an ordinary aquarium additive. I would also label the bottle clearly and keep it away from kids and pets.

One practical point: with a 0.01 g scale, your 0.81 g weighing has roughly ±0.01 g resolution, which is about a 1.2% difference, so the resulting stock should be plenty close for this purpose.
I just double checked the math myself. Your statement about the factor of 10 is not correct. Randy's math checks out. I also don't think there is such a thing as Anhydrous NiCl2*6H2O, only Hexahydrate.
 

TOP 10 Trending Threads

WHAT KIND OF REEFING DEAL ARE YOU HOPING TO PICK UP THIS BLACK FRIDAY?

  • A whole new aquarium or complete system

    Votes: 1 10.0%
  • Lighting, pumps, or other major equipment

    Votes: 2 20.0%
  • Controllers, testing, dosing, or automation gear

    Votes: 1 10.0%
  • Dry goods and restocks, like salt, media, or food

    Votes: 1 10.0%
  • Corals! Must...Have...CORALS!!!

    Votes: 2 20.0%
  • Fish or other livestock

    Votes: 0 0.0%
  • Rock, sand, or other aquascaping supplies

    Votes: 1 10.0%
  • I’m browsing, but don’t have a specific target

    Votes: 1 10.0%
  • I’m not shopping for reef deals this year

    Votes: 0 0.0%
  • Other (Post in the comments)

    Votes: 1 10.0%
Back
Top
Home
Post thread…
Market
What's new